Electronically controlled instant hot water up to 50Â°C with the DHCE 6/50 and DHCE 8/50.
The electronically controlled DHCE single phase instantaneous water heaters from STIEBEL ELTRON. These single phase instant hot water systems are ideal for low flow installations as the water heater has a switch on flow rate at only 1.5 litres per minute. With installation flexibility in mind, the DHCE hot water system is compact in design and ideal for those applications where space is tight.
- Modern carbon look design
- Electronically controlled
- Three selectable temperature outputs for greater convenience
- Tubular heating element
- WaterMark approved, Lic. No. WMKA21273, AS3498
- Delivers a maximum of 50Â°C hot water in accordance with AS3498
- No safe tray or drainage required (check local regulations)
- Space saving compact design
Save water and energy
The DHCE compact water heater utilises electronic control that helps to save energy and water compared to older style hydraulically controlled instantaneous water heaters.
In addition, the compact design allows for close to the point of use installation to help save water by reducing the time it takes to deliver hot water to the outlet. The advantage of an instantaneous water heater is that no heat is lost, and energy wasted, to store hot water at temperature. Energy is only required to heat water when the hot water outlet is switched on.
Available in two electrical sizes:
- DHCE 6/50 - 7.1kW, 30 Amps, single phase 240V
- DHCE 8/50 - 9.5kW, 40 Amps, single phase 240V
- 5 year full parts and labour domestic warranty*
*Conditions apply - refer warranty policy for full details.
|Model number||DHCE 6/50||DHCE 8/50|
|Rated output (240V)||7.1kW||9.5kW|
|Rated current (240V)||30Amp||40Amp|
|Phases||1/N/PE/AC 220..240V||1/N/PE/AC 220..240V|
|Electrical Installation||As per AS/NZS3000|
|Installation requirements||AS/NZS3500.4.2 & local requirements|
|Switch on flow rate (minimum flow rate required to switch on the water heater)||1.5L/min||1.5L/min|
|Permissible operating pressure||1000kPa||1000kPa|
|Temperature adjustment||ï¿½ï¿½40Â°C ï¿½ï¿½ï¿½ï¿½ 45Â°C ï¿½ï¿½ï¿½ï¿½ï¿½ï¿½50Â°C||ï¿½ï¿½40Â°C ï¿½ï¿½ï¿½ï¿½ 45Â°C ï¿½ï¿½ï¿½ï¿½ï¿½ï¿½50Â°C|
|Weight (filled with water)||2.45kg||2.45kg|
|Colour||Silver look||Silver look|
|Approvals||WaterMark Lic No. WMKA21273, AS3498|
|For one/several draw off points||Yes/Yes||Yes/Yes|
|Electronic flow rate control||No||No|
|Electronic air detection system||No||No|
|Accepts pre-heated water (solar)||No||No|
|DHCE 6/50 Data Sheet||Data Sheet||
|DHCE 8/50 Data Sheet||Data Sheet||
|DHCE Operation and Installation Guide||Operation and Installation Guide||
|DHCE 6/50 / DHCE 8/50 Warranty||Warranty||
|Revit file of STIEBEL ELTRON's DHCE||Technical Drawing||
|STIEBEL ELTRON Tech Line Drawing DHCE 50||Technical Drawing||
|STIEBEL ELTRON Exploded Diagram DHCE||Exploded Diagram||
|Model & Serial Number Location||Serial Number Location||
No, all of the DHCE single phase instantaneous water heaters require a dedicated hard-wired circuit as they draw more than 10 Amps.
The DHCE instant hot water systems can be installed almost anywhere due to their compact design. The water heater does not require ventilation, relief drain or safe trays so it can be installed in a cupboard, in the roof space, below the sink, in a service cavity, in a Euro laundry just to name a few options.
Yes, the DHCE has a switch on flow rate of only 1.5L/min making them ideal water heaters to use with low flow tapware.
The DHCE instant hot water system will not deliver the same temperature hot water at the same flow rates as an electric storage water heater. Please contact our customer service team on 1800 153 351 to determine which instantaneous water heater is right for your application.
The DHCEs are designed to be installed as close as practical to the most used hot water outlet. Installing closer to the point of use can help to save water and energy by delivering hot water quickly to the outlet. The STIEBEL ELTRON single phase electric instantaneous water heaters are designed to service multiple outlets (note that this is will depend on the DHCE model selected) located several metres away from the system.